top of page
3d printed rc plane Funbus
Planeprint 3d printed rc plane Funbus
3d printing profiles

Cura 4.12.1 required! More info here ...


Fully 3D printable RC airplane designed and developed by René Marschall

  • Wingspan: 1000 mm (39.3 inches)

  • Flight weight: from 390 grams

  • Wingload: 18g/dm2

  • 5 channel

  • Motorization: 2S or 3S

  • Material: LW-PLA400g/PLA50g/TPU5g

  • Printer space of 200x200x200 mm (cube) needed!

  •  NOTE  Slicing only works with CURA! look here why…
The Planeprint Funbus flies over the Lienz Dolomites.

The Planeprint Funbus is a small super light 3D printable parkflyer based on the Airbus A380.

Our design goal was to achieve as low a flying weight as possible, so we did not use EDF motors but instead put a lightweight shockflyer drive in the nose. This and the extremely slow airfoil allows a very slow airspeed and flying in relatively limited space. Another advantage of this design is the very low cost of the RC electronics. 

The Funbus is equipped with large wheels and can be launched and landed on any short mowed meadow.

Flying fun is guaranteed!

Fully 3d printed rc plane Funbus by Planeprint
Fully 3d printed rc plane Funbus by Planeprint


Download our free PRINTING & ASSEMBLING MANUAL, here you can see exactly what to expect before you decide to buy the STL data.

3d printing and assembling manual

PDF MANUAL V1.6 free for download

We are constantly improving the manuals. Check if you have the latest version.

bottom of page